Nonogram techniques, from the first clue to the last square
To solve a nonogram, never guess where a block goes. Look for squares that are filled in every possible arrangement of a clue, mark them, and cross out the squares that can never be filled. Each new square changes the lines that cross it, so you keep switching between rows and columns. The overlap method, empty squares and the edges of the grid do almost all of the work.
Read a clue as a sum
A clue such as 3 1 2 says the line holds a block of three, a block of one and a block of two, in that order, with at least one empty square between neighboring blocks. The smallest space these blocks can fit into is their total plus the compulsory gaps: 3 + 1 + 2 + 2 = 8. In a line of ten squares that leaves only two squares of slack, and slack is what tells you how much freedom the blocks have.
Make this sum a habit before you place anything. When the total equals the length of the line, the whole line is decided at once: blocks and gaps fall exactly into place. When the slack is small, the overlap method below gives you many squares straight away. When the slack is large, the clue alone gives little, and the line has to wait until its neighbors have told you more.
The overlap method
Push every block as far left as it can go, then as far right. Any square covered by the same block in both positions must be filled. A single block of 7 in a line of 10 can start no later than the fourth square, so squares 4 to 7 are filled whatever happens. In general, a block fills as many middle squares as its length minus the slack, so a block of 7 with a slack of 3 gives you 4 certain squares.
The method works for every block of a clue, not only for single-block lines. In 3 1 2 on ten squares, the leftmost and rightmost positions of the 3 overlap by one square, because the slack is 2. Later, when some squares are already filled or crossed, repeat the same idea inside the space that is still open. Most of the progress on large grids comes from this one move, applied again and again as the lines fill up.
Use the empty squares
Crossing out squares that must stay empty is not decoration; it is half of the logic. If a row with the clue 2 already has its block of two, every other square of that row is empty. Here the game crosses those squares for you with light dots as soon as the filled squares of a line match its clue, but the deductions in between are yours to mark.
Crosses shorten the space a block can use. A gap of two squares between two crosses can never hold a block of three, so those two squares are empty as well. Look for such pockets near crosses and near the borders: a short pocket that is too small for every remaining block can be crossed out completely, and a pocket that fits exactly one block becomes a small overlap problem of its own.
Work from the edges and the first block
A filled square close to the border pins down the first block of that line. If the clue starts with 4 and the second square is filled, the block of four must cover that square, so it lies somewhere in squares 1 to 5, and squares 2 to 4 are certainly filled. If the very first square is filled, the whole first block starts there and the square right after it is empty.
The same reasoning works for the last block from the other end, and for blocks next to a crossed square. A filled square that is too far from the edge to belong to the first block tells you it belongs to the second one. Each time you finish a block that touches a border or a cross, put a cross after it: that closed block often settles the crossing column too.
What each grid size asks of you
The four sizes use the same rules; what changes is how long you have to keep a chain of reasoning going.
- 5×5: most rows are decided by the sum alone. Use it to get the feel of reading clues and crossing out squares.
- 10×10: the classic size. The overlap method gives the first squares, and the rest comes from switching between rows and columns.
- 15×15: long clues with several blocks and more slack. Expect to gain one or two squares per line at a time and to revisit the same lines often.
- 20×20: the big picture, offered on tablets and computers. Work in passes over all rows, then all columns, and use the preview in the corner to see the shape emerge.
Mistakes that slow you down
Most stuck positions come from one of these habits rather than from a hard puzzle.
- Filling a square because it looks right for the picture. The picture is the result of the logic, never a reason for a move.
- Forgetting the gaps. Two blocks of a clue are never adjacent, so a filled square right after a finished block is a mistake.
- Not crossing out. Without crosses, short pockets and closed blocks are hard to see, and the overlap method has less to work with.
- Staying on one line. When a row gives nothing, the answer is almost always in a column that crosses it.
Questions about getting better
Do nonograms ever require guessing?
Not the ones on this site. Every picture is checked before it is added: a line-by-line solver must finish it without trial and error, which also guarantees that the solution is unique.
What does a 0 clue mean?
The whole line is empty. You can cross out every square in it straight away, which often helps the columns that cross it.
Why do the clue numbers turn gray?
A gray number belongs to a block you have already completed and closed off with crosses or the border. When every number of a line is gray, the line matches its clue.
How do hints work?
A hint first corrects a square you have filled or crossed wrongly. If everything is right, it shows the next square that follows from one row or column clue and names that clue, so you can see the reasoning.